Concrete Patio Cost in North Carolina
2026 estimates — plain, stamped, stained, and exposed aggregate
300 sqft plain concrete patio, North Carolina labor rates. Updated June 2026.
Calculate Your North Carolina Concrete Patio Cost
Concrete Patio Cost by Finish — North Carolina 2026 (300 sqft)
| Finish Type | 300 sqft (NC) | Per sqft |
|---|---|---|
| Plain / Broom-finish | $2,138 | $7.13/sqft |
| Colored concrete | $2,993 | $9.97/sqft |
| Acid-stained | $2,708 | $9.03/sqft |
| Exposed aggregate | $3,277 | $10.92/sqft |
| Stamped concrete | $4,703 | $15.67/sqft |
Concrete Patios in North Carolina — Key Facts
1. North Carolina Pricing
Concrete patio installation in North Carolina is near the national average. Plain concrete ($$7.13/sqft) to stamped ($$15.67/sqft). Stamped concrete mimics pavers at 30–50% lower cost.
2. North Carolina Climate Considerations
North Carolina has mild winters with occasional freezes (particularly in the piedmont and mountains), so freeze-thaw protection is moderate — air-entrained concrete is still recommended for the mountains and Piedmont. NC's high humidity can stain light-colored concrete; acid-staining or integral coloring helps mask future staining. Charlotte and Raleigh have many concrete contractors — get 3 quotes for best pricing.
3. Concrete vs. Pavers vs. Wood Deck
Concrete ($$7–$16/sqft) is the most affordable for ground-level patios in North Carolina and lasts 25–50 years. Pavers cost 60–80% more but allow easy individual tile replacement. Wood decks make more sense for elevated installations on sloped yards.
FAQs — Concrete Patio Cost in North Carolina
Concrete patio installation in North Carolina costs $2,660 on average for a 300 sqft plain patio — below the national average. NC's mild climate means excellent durability with standard concrete. Stamped: $4,703 for 300 sqft; plain broom-finish: $2,138. Charlotte and Raleigh-Durham run 10–15% above state average.
Stamped concrete costs $4,703 vs $2,138 for plain concrete for 300 sqft in North Carolina. The premium delivers a decorative appearance similar to stone or brick pavers at 30–50% less cost. Stamped concrete requires resealing every 2–3 years to maintain appearance.
A properly installed and sealed concrete patio lasts 25–50 years in North Carolina. Key factors: proper base preparation (4–6 inches compacted gravel), reinforcement (rebar or fiber mesh), correct drainage slope, and sealing every 2–3 years. In freeze-thaw climates, use air-entrained concrete and avoid deicing salts.
Concrete costs $2,138–$4,703 for 300 sqft in North Carolina; pavers cost $5,130–$8,550. Pavers allow individual replacement if cracked, drain naturally, and maintain good value. Concrete is lower upfront cost but can crack (especially in freeze-thaw climates) and cracks are visible. Stamped concrete bridges the gap aesthetically at mid-range cost.
Most North Carolina jurisdictions do not require permits for ground-level patios under 200 sqft that are not attached to the house structure. However, permits are typically needed for: patios larger than 200–300 sqft, raised patios or those attached to the home, covered patios/pergolas, and patios in HOA communities. Check with your local building department — permit costs average $50–$150 for patios.
Get Free Concrete Patio Quotes in North Carolina
Compare 3+ licensed concrete contractors. Most homeowners save 20–30% by getting multiple bids.
Get Free Quotes on AngiNorth Carolina Patio Summary
- →Plain avg: $2,138 / 300 sqft
- →Stamped: $4,703 / 300 sqft
- →Range: $1,995 – $3,724
- →Cost index: near national avg